:: MG ZR forum - View Single Post - Track Car Build
Thread: Track Car Build
View Single Post
Old 29-03-2015, 18:37   #1 (permalink)
*Newbie* Handle with care

Posts: 5
Location: Wiltshire
Drives: ZR 160
Join Date: Nov 2011
iTrader: 0 (0%)
Thanks: 0
Thanked 0 Times in 0 Posts
ratface is on a distinguished road
370BHP ZR Track Car

In case you've not seen it over on Rovertech here is our little build which has taken a couple of years so far

I forgot to get any pics when it arrived, but it was a tidy ZR 160

As it looked stripped, almost ready for the Custom Cages International weld in roll cage, which I'm not looking forward to fitting

Nearly finished playing with the scaffolding

Caliper brakets made and 330mm front brakes now fitted with brembo radials

A bit of paint

M Series manifold modified to take the Cosworth throttle body

And then onto the fuel lines

Still need to tig weld the return line at the 90 bend

And fix the 044 pump and tank

After removing the front of the car including the cross member the RS500 cooler was fitted into place

Then it was time to warm up the TIG and make a water return pipe

Whilst the TIG was out it was time to make the air intake

Last edited by ratface; 11-07-2019 at 07:59.
ratface is offline   Reply With Quote