MG ZR Forums banner
1 - 20 of 44 Posts

·
R5 GT TURBO OWNER
Joined
·
3,131 Posts
Discussion Starter · #1 ·
just been on youtube looking at zed vids and had a look at andyr140s vid and some guy has posted claiming the most unreal bhp claim that his zr 160 is putting out with these following mods read and laugh


I to own a MG ZR 160!
> 52mm throttle body
> Full stainless steel exhaust system
> ITG Maxogen air filter (carbon fibre)
> Ultra lightweight flywheel
> R140 camshafts
> Carbon fibre hoses
> Crankshaft (ultra light)
> Super chipped
> modified cylinder head
> New pistons
> Custom re-mapping
> HKS spark plugs
> Koni lowering kit
> EBC braking system
> Big end bearing set

Dynamometer:
Standard: 157.6 BHP 0-60 7.4 sec 136 MPH
Modifications: 258.2 BHP 0-60 6.0 sec 142 MPH
 

·
R5 GT TURBO OWNER
Joined
·
3,131 Posts
Discussion Starter · #4 ·
spot the numerous faults in there i think somebody is full of u know wot

r140 cams - they dont go in vvc even if it was converted run solid cams which it aint you would use 285s or similar

superchipped and custom re mapping so which one is it lol

haha 258bhp
 

·
R5 GT TURBO OWNER
Joined
·
3,131 Posts
Discussion Starter · #14 ·
i lol'ed at that figure, and a 52mm ta is standard on the 160.....or is that an ultra lightweight one aswell?? :D
haha exactly mate id love this person come on here just for the fun factor, i reckon its some kid who wants a zed when he can drive so has just made all that up because surely nobody in there right mind would post that
 

·
R5 GT TURBO OWNER
Joined
·
3,131 Posts
Discussion Starter · #16 ·
its going well mate sorted a deal on a full vvc bottom end that will be with me friday so my car will be a 1.8 throttle bodied zed. iv also got a spare cylinder head that im sending in for a big valve conversion and full porting. also im goin put a lightweight flywheel on there when all the work is being done. should be fun when its finished
 

·
R5 GT TURBO OWNER
Joined
·
3,131 Posts
Discussion Starter · #18 ·
well a standard gain would be from 103 bhp to 118bhp and about 90lb/ft torque to 122lb/ft torque but with the mods i have it should gain quite a bit
 
1 - 20 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top